- Simplify config and fix partial hashing
- Add partial function calls
- All partial state is handled internally
- All functions now use the classic naming convention.
All operations expect the destination buffer to fit the selected size.
And for simplicity STATE_WAIT is not supported.
Additionally, remove single block ECB and just use the normal function.
The defragmentation runs on every free and it only merges subsequent nodes.
So there's no point of looping all nodes.
So, just check if previous and next nodes are mergeable.
This makes free performant and achieves the same exact functionality.
- Allow rebuilds without rebuilding everything
By detecting changes everywhere that matters (flags, objects and headers).
- Add progress bar
- Fully clean everything when clean goal is used
Utilize charger config set command which allows for supplement mode.
Additionally, remove ping config when SIO and parse buttons/sticks on subcmd reports.
- Add delay after a DSI soft reset
- Remove more duplicated configs
- Improve code to save code size
- Improve comments
- Do not allow display_backlight to be used with OLED
- Convert access from min cluster size to block size
Also allow read/writes to less than cluster size
- In case of intercluster access throw an error
- Do not error on zero size
On reads buffer still needs to be block (instead of cluster) aligned.
On writes, buffer still needs to be readable out of bounds.
T21X v0.1:
- Add IRB/no table support
T210 v1.6/Common:
- Add a proper table for 8GB T210 config instead of editing a 4GB one
- Increase timeout to 2ms
- Generally improve checks and guard against unknown SoCs/SKUs
- Remove the long ago obsolete OVERCLOCK_FREQ/OVERCLOCK_VOLTAGE ifdefs
- Compact and group relevant values together
- Use actual value name instead of register name where possible
- Fix LOT code masking
- Fully parse and show LOT code (it's the same marking on die)
- Correct X coordinate parsing (9bit 2s complement)
- Add product code
- Use 6 as divm and div1 for OUT1 to avoid having very high frequency on OUT0
There seems to be an undocumented silicon errata where PLLC OUT0 produces EMI
to input mux logic in modules, even when not using it.
- Always check if PLL is enabled and disable first in order to avoid a silicon
errata with hybrid PLLs
- Fix PLLC_FLL_LD_MEM value
This is not mandatory but removes unnecessary load-mask/or-stores.
On the other hand, due to an undocumented T210 silicon errata,
these are mandatory for SDMMC modules.
This is because a fraction of T210 chips can glitch out and cause SoC hang.
T210B01 is not affected.
The NOGC sdmmc memio patch was incorrectly changing the register that keeps the value for HOS 21.0.0.
Refactored all patches to stop patching the whole op and just change the value from 0x200 to 0x400.
- Allow invalid/out-of-bounds and empty partitions to be removed from GPT
- Add fix for wrong emuMMC offset because of older bugged Android Dynamic scheme
- Fix the verification % and bar if restored backup is smaller than partition
- Use orange bar for restoring when writing to eMMC/emuMMC.
- Fix bar color on restoring after verification
- Allow verification to be aborted for all parts in partial mode (FAT32 or small card)
- "Perf" hack removal (match L4T mini Minerva)
It's not a performance hack, it just kills low power modes.
If wanted in L4T, use HP Mode in `ram_oc_opt`.
- Simplify of burst regs config
- Refactor of several bit defines and variables
The biggest take here is that the split approach of having it in Bootrom and
Bootloader is that it's only for boot. Any later powerdown must rerun the WAR
for that particular power domain.