All operations expect the destination buffer to fit the selected size.
And for simplicity STATE_WAIT is not supported.
Additionally, remove single block ECB and just use the normal function.
The defragmentation runs on every free and it only merges subsequent nodes.
So there's no point of looping all nodes.
So, just check if previous and next nodes are mergeable.
This makes free performant and achieves the same exact functionality.
Utilize charger config set command which allows for supplement mode.
Additionally, remove ping config when SIO and parse buttons/sticks on subcmd reports.
- Add delay after a DSI soft reset
- Remove more duplicated configs
- Improve code to save code size
- Improve comments
- Do not allow display_backlight to be used with OLED
- Convert access from min cluster size to block size
Also allow read/writes to less than cluster size
- In case of intercluster access throw an error
- Do not error on zero size
On reads buffer still needs to be block (instead of cluster) aligned.
On writes, buffer still needs to be readable out of bounds.
- Use 6 as divm and div1 for OUT1 to avoid having very high frequency on OUT0
There seems to be an undocumented silicon errata where PLLC OUT0 produces EMI
to input mux logic in modules, even when not using it.
- Always check if PLL is enabled and disable first in order to avoid a silicon
errata with hybrid PLLs
- Fix PLLC_FLL_LD_MEM value
This is not mandatory but removes unnecessary load-mask/or-stores.
On the other hand, due to an undocumented T210 silicon errata,
these are mandatory for SDMMC modules.
This is because a fraction of T210 chips can glitch out and cause SoC hang.
T210B01 is not affected.
The biggest take here is that the split approach of having it in Bootrom and
Bootloader is that it's only for boot. Any later powerdown must rerun the WAR
for that particular power domain.
For HOS <= 3.0.2 the carveouts are set by bootloader and sdram config actually does not set them.
So add which need different value from reset and also make sure that data is flushed for WPR config.
